WORKS Exhale Exhaust Series: The WORKS modular Exhale series components allow EVO enthusiasts to quickly and easily mix and match the Exhale DP (Down Pipe), HFC (High Flow Cat), IP (Intermediate Pipe), and ABM (Axle Back Muffler) with the factory EVO VIII exhaust components. All WORKS jigs are created using the factory OEM exhaust pieces to ensure a precise and perfect fit every time. The Exhale series are manufactured in the USA using 100% T-304 Stainless Steel, mandrel bent, and includes all of the necessary gaskets, high-heat hardware, and installation instructions.WORKS High Flow Cat: The WORKS HFC allows maximum exhaust flow while still maintaining emissions requirements. We tested multiple substrates on multiple EVOs for thousands of miles to ensure compliance which would prevent triggering the CEL. Weight is also reduced by over 4 pounds. Constructed using 76mm (3.0") stainless steel, 10mm thick flanges, and incorporates TWO heat shields (upper and lower) to encapsulate the heat for performance and safety. Includes all new special hardware, custom WORKS gaskets, and installation instructions. Application: '03-'05 EVO VIII; '06 EVO IX requires additional bung to be added or an EVO VIII style Intermediate Pipe with a pre-existing bung for the rear O2 sensor.*For Off-Road Use Only*WRP (WORKS Racing Program) items are engineered to provide increased performance and may not be intended for use on public roads. Because we expect these products to be put through some extreme situations, certain items may not qualify for the WORKS Factory-matched Warranty.

EDO Reward Points : 269 points